Key facts

  • •Each state electricity regulatory commission sets its own windows and rates in its tariff order.
  • •Surcharges and rebates are usually a percentage of the normal energy charge.
  • •Applicability varies: mandatory for some categories, optional for others, sometimes above a load threshold.
  • •Solar has moved the cheap period towards midday in many states, with the expensive hours after sunset.
  • •The windows and spread are revised over time, so last year’s figures are not a safe basis for a capital decision.

How it works

The day is cut into peak, normal and off-peak or rebate periods. Electricity costs the system more to supply at some hours than others, and a ToD tariff passes part of that signal to the consumer in the hope that load moves.

Most HT bills show units recorded in each slot. Because the surcharge and rebate are percentages, the rupee spread between the dearest and cheapest unit changes whenever the base energy charge is revised.

Worked example

These figures are illustrative, not any state’s tariff. Take a normal rate of ₹8 per unit, a 20 per cent peak surcharge and a 20 per cent solar-hours rebate. The peak rate is ₹9.60, the rebate rate ₹6.40, and the spread ₹3.20.

A site uses 10,000 units a month: 3,000 at peak, 5,000 normal and 2,000 in the rebate window. The energy charge is ₹28,800 + ₹40,000 + ₹12,800 = ₹81,600, against ₹80,000 at a single ₹8 rate. Its load shape costs it ₹1,600 a month.

If the base rate rises to ₹9 with the same percentages, the peak rate is ₹10.80, the rebate rate ₹7.20, and the spread ₹3.60. Nothing about the site changed, but the value of moving a unit did.

Why it matters to a buyer in India

A factory that cannot move its shift can respond through a battery, charging in the rebate window and discharging in the peak. A large share of units in the peak slot gives a battery something to work with. If almost all consumption is already in normal or rebate hours, ToD alone will not justify storage.

Common mistakes

Check these before relying on a ToD saving:

  • •Using another state’s windows, or an old tariff order, instead of the current schedule from your DISCOM.
  • •Missing seasonal differences between summer and winter windows.
  • •Treating the spread as permanent. It can move either way at the next tariff order, so test a smaller one.
  • •Assuming ToD applies to your category without confirming it on the schedule.

Frequently asked questions

Where can I find my current ToD rates and hours?+

In the current tariff order from your state electricity regulatory commission, or the tariff schedule published by your DISCOM. Your bill usually shows units by slot and the surcharge or rebate applied. This glossary does not quote rates, because they are revised and differ by state and consumer category.

Is night always the cheapest time to use electricity?+

No. Night was the traditional cheap period, but large amounts of solar have created a midday surplus in many places, and some states now price solar hours lowest. Check the windows on your own schedule rather than assuming, especially if you are planning when a battery should charge.

Read more

Related terms

Is storage right for your site?

Send us a month of electricity bills and your load profile, and we will tell you what a battery would save — including when it would not pay.

All glossary terms