Key facts

  • •Nominal cell voltage is 3.2 V, so 16 cells in series make a 51.2 V pack
  • •It contains no cobalt or nickel
  • •It is heavier and bulkier than NMC for the same energy
  • •Its voltage is nearly flat over most of a discharge, which steadies output but complicates charge estimation
  • •Charging below about 0 °C can damage it, so a BMS should block it

How it compares

LFP is the usual choice where weight matters less than longevity and safety margin: e-rickshaws, commuter two-wheelers, stationary storage and home backup. NMC stores more energy per kilogram and suits tight packaging, with less thermal margin and typically shorter cycle life. Lead-acid costs least on the day of purchase, is heaviest for its usable energy and delivers a fraction of the cycles.

“Lithium” alone is a category, not a specification. Ask for the chemistry in writing. A well-built NMC pack can still outperform a badly built LFP pack, so chemistry is necessary but not sufficient.

A worked example: home backup

Suppose a home needs 1 kW for four hours, or 4 kWh at the load. With an illustrative 90 per cent inverter efficiency and an 80 per cent usable window, the battery needs 4 ÷ (0.9 × 0.8), or about 5.6 kWh nameplate. A 51.2 V, 110 Ah pack is about 5.63 kWh, which just covers it when new.

Lead-acid limited to 50 per cent discharge would need 4 ÷ (0.9 × 0.5), or about 8.9 kWh. At 1.8 kWh per 12 V, 150 Ah battery, that is five batteries, before allowing for lead-acid’s lower capacity at higher discharge rates. These are planning figures: size from your own night-time or outage consumption, and check the inverter’s kW rating separately.

What it means in Indian conditions

Thermal tolerance is a safety margin, not protection from heat. An LFP pack in a hot, unventilated space still ages faster, so location matters. Good ventilation and shade help any home installation.

Common mistakes

  • •Comparing prices per Ah across different voltages instead of per kWh
  • •Assuming LFP cannot catch fire
  • •Using a charger not matched to the pack
  • •Connecting it to an old lead-acid inverter without checking that its charge settings suit LFP

Frequently asked questions

Is LFP the same as lithium-ion?+

LFP is one kind of lithium-ion battery. The term lithium-ion covers several cathode chemistries, including NMC and LFP, which differ in energy density, thermal behaviour and life. When a seller says lithium-ion without further detail, ask which chemistry is inside.

Can an LFP battery directly replace a lead-acid inverter battery?+

Only if the inverter can charge it correctly. LFP needs its own charge voltage profile and no long float stage designed for lead-acid. Check that the inverter has an LFP setting or is approved for the pack, and that the pack’s BMS can supply the inverter’s peak current.

Read more

Related terms

Replacing an inverter battery?

Tell us what you need to keep running during a cut, and we will size a lithium pack to it — and say so if a tubular battery is the cheaper choice.

Popular: Lithium inverter battery

All glossary terms