Battery management system (BMS)
A battery management system (BMS) is the electronics that monitor a battery’s cells, keep them balanced and disconnect the battery if anything goes outside safe limits. It protects the cells, but it does not decide when a system charges or discharges.
Key facts
- •It measures cell voltages, temperatures and current many times a second
- •It estimates state of charge and state of health
- •It publishes the maximum charge and discharge current allowed at that moment
- •Balancing is either passive, bleeding excess as heat, or active, moving charge between cells
- •A BMS that watches only total pack voltage cannot see one failing cell
How it works
Cells in series carry the same current, so charging must stop when the fullest cell is full and discharging must stop when the emptiest is empty. The BMS enforces those limits for each cell, along with limits on temperature and current. If they are breached, it opens the contactors or switches. That is safe but abrupt, so in a storage system the layers above are expected to respect its published limits first.
A worked example: the weakest cell sets the pack
Take an illustrative 16-cell, 51.2 V pack with 100 Ah cells, nominally 5.12 kWh. If one cell has fallen to 90 Ah, the BMS must stop discharge when that cell is empty, so the pack delivers only about 90 Ah. That is 90 × 51.2, or about 4.61 kWh, a loss of about 10 per cent caused by one cell.
Balancing helps when cells differ in charge. It cannot give a cell capacity it has physically lost. That is why replacing one cell in an aged pack without matching it and rebalancing the pack so often fails.
Why it matters to a buyer
A weak BMS on good cells produces a bad battery. For a vehicle or home pack, ask what it protects against, listed individually. In a storage system, it is one layer of a stack that includes the power conversion system and the energy management system, so ask who is accountable for making them work together.
- •Over-charge and over-discharge at cell level
- •Over-current and short circuit
- •Temperature cut-off on both charge and discharge
- •Individual cell monitoring and the balancing method
- •What data can be read, by whom, and whether fault logs are kept
Common mistakes
- •Treating the BMS as an accessory rather than half of the product
- •Assuming a BMS makes an unmatched charger safe
- •Always unplugging early, so that passive balancing rarely has a chance to run
Frequently asked questions
What happens when a BMS fails?+
It depends on the failure. Most often the pack shuts down or refuses to charge, which is inconvenient but safe. A failure that leaves the battery connected with protection disabled is more dangerous. Stop using the pack, and do not bypass the BMS to restore power.
Can a battery run without a BMS?+
A lithium pack should not. Without one, nothing prevents an individual cell from being over-charged or over-discharged, even when total pack voltage looks normal. Over-charging is a recognised route to thermal runaway, and imbalance would steadily reduce the capacity available.
Read more
- BMS, PCS, EMS and SCADA: The Control Stack Inside a Battery Storage System Explainer
- Can a Lithium Battery Work With Your Existing Home Inverter? Home storage
- Nebula Electronics: Battery Pack and BMS Test Systems Industry
- Buying a Used or Refurbished Lithium Battery: What to Check Buying guide
- How to Read a Lithium Battery Spec Sheet Before You Buy Explainer
- Reading a Lithium Battery Warranty: What “Five Years” Actually Covers Buying guide
Related terms
Is storage right for your site?
Send us a month of electricity bills and your load profile, and we will tell you what a battery would save — including when it would not pay.