C-rate
C-rate is how fast a battery is charged or discharged relative to its capacity. At 1C a pack delivers its full capacity in one hour, at 0.5C in two hours and at 2C in thirty minutes.
Key facts
- •C-rate = current in amps ÷ capacity in amp-hours, or power in kW ÷ energy in kWh
- •Hours to empty or fill is roughly 1 ÷ C-rate
- •Higher C-rates mean more heat, because resistive loss rises with the square of current
- •Spec sheets usually state separate limits for continuous discharge, peak discharge and charge
- •The same rate is harder on a cell at high temperature or near full and empty
A worked example
Take an illustrative 51.2 V, 100 Ah pack, which stores 5.12 kWh. At 1C it carries 100 A and delivers about 5.12 kW. At 0.5C it carries 50 A and delivers about 2.56 kW.
Suppose a loaded vehicle draws 3.2 kW climbing a flyover. That is 3,200 W ÷ 51.2 V = 62.5 A, or 0.625C, so the pack’s continuous discharge rating must exceed 0.625C. A 20 A charger is 0.2C and needs about five hours from empty, plus a little more because current tapers near the top. A 50 A charger is 0.5C and needs a little over two.
The arithmetic scales. A 500 kWh commercial system at 1C is a 500 kW system; at 0.5C it is 250 kW.
Why it matters to a buyer
For a vehicle, the discharge rate has to cover the worst load on the route, not cruising. An undersized pack runs hot on loaded climbs or trips its protection. Sustained fast charging is convenient, and over years it is harder on the cells: a real trade-off to weigh against the time a vehicle stands idle.
For a storage system, a quote that gives only kWh omits the C-rate, and that is often where a cheaper system differs. Warranties are commonly written against a stated C-rate, so operating outside it can void the assumption a financial model rests on.
Common mistakes
- •Reading a peak rating, held for seconds, as if it were continuous
- •Assuming capacity is the same at every rate: usable energy falls somewhat as the rate rises
- •Checking the discharge rate and forgetting the charge limit, which is often lower
Frequently asked questions
Is a higher C-rate better?+
Only if the job needs it. A higher rating gives more power from the same energy and usually costs more. Running cells harder than necessary adds heat and speeds ageing, so the sensible target is a rating comfortably above the real load.
What does 0.2C mean on a charger?+
It means a charging current equal to one fifth of the pack’s amp-hour capacity: 20 A on a 100 Ah pack. A full charge from empty takes about five hours, and slightly longer in practice because the current reduces as the pack approaches full.
Read more
- Sizing a Commercial BESS: kW versus kWh, C-Rate and Duty Cycle Explained C&I storage
- Sizing a Grid Battery: Power, Energy, Duration and the Augmentation Problem Grid storage
- How to Read a Lithium Battery Spec Sheet Before You Buy Explainer
- Reading a BESS Warranty: Capacity, Throughput and Performance Guarantees C&I storage
- Liquid vs Air Cooling in Battery Storage: Which Suits Your Site? Explainer
Related terms
Thinking about upgrading?
Talk to our team about the right pack for your vehicle, and about EMI options that keep the monthly outgo close to what you already spend.
Popular: Lithium e-rickshaw battery