Sunkko Spot Welders for Battery Pack Assembly
Sunkko’s handheld, benchtop and pneumatic spot welders: which suits which nickel strip, their limits, and how to avoid buying a copy.
Published: 20 November 2026
Industry · 4 min read
At a glance
- •Sunkko, which began as a small workshop in Shenzhen in 2001 and made its first spot welder in 2003
- •Privately held
- •Battery spot welders and pack-assembly tools
- •Sold through its own distributors and through online marketplaces
- •Suits small and mid-sized pack assemblers and battery workshops
What Sunkko makes
A spot welder joins nickel strip to cell terminals with a short pulse of high current. Get it right and the joint is strong and the cell stays cool; get it wrong and the joint either comes loose under vibration or the cell is heated where it should not be. Sunkko’s welders are often the first welding equipment a small assembler buys.
- •Portable and handheld welders. Models such as the 737G series, for light nickel strip of roughly 0.15–0.35 mm.
- •Benchtop welders. Higher-power machines with a welding pen and automatic or manual triggering, for thicker strip.
- •Pneumatic welders. Industrial models in which air pressure, not the operator’s hand, presses the electrodes, so every weld gets the same force.
- •Accessories. Welding pens, electrodes, nickel strip and soldering tools.
Voltage and internal-resistance testers carrying the Sunkko name are also sold online. Welding is the core range, so confirm the model and specification with the factory before relying on one.
Strengths
- •Low cost and easy to find, with spares and electrodes readily available
- •Simple to operate, which suits small teams and manual assembly
- •More than twenty years in the workshop and small-industry segment
Limitations
- •A welder maker, not an automation or test-system maker: most models do not log data or connect to a line
- •On manual models, weld quality depends on the operator; pneumatic models are better for production
- •Copies are sold online alongside genuine units, and quality differs
Who it suits
Small and mid-sized pack assemblers, e-rickshaw and e-bike battery workshops, and repair shops. A plant building more than a few hundred packs a month will usually want pneumatic models, or move to laser welding, for consistency.
Before you buy
- •Match the welder to the strip: thin pure nickel (about 0.15–0.2 mm) suits small packs, while 0.3–0.4 mm strip or nickel-plated copper for high-current packs needs a higher-power pneumatic model
- •Buy from the official store or an authorised dealer to avoid copies
- •Ask for a 230 V version with an Indian plug, and order spare electrodes at the same time
Before buying from any Chinese supplier
Whichever maker you choose, the same checks apply: the exact specification you need, software that exports your data, 230 V operation, a calibration certificate, local service and spares, a factory acceptance test with your own cells, and the full landed cost from your customs agent. Our overview of Chinese battery test and assembly equipment sets these out and compares the other makers in the series.
Frequently asked questions
Which spot welder do I need for nickel strip?+
Thin pure nickel of about 0.15–0.2 mm suits small packs and lighter welders. Strip of 0.3–0.4 mm, or nickel-plated copper for high-current packs, needs a higher-power pneumatic welder.
Why choose a pneumatic spot welder?+
Because air pressure, not the operator’s hand, presses the electrodes, so every weld gets the same force. That makes welds more consistent in production than on a manual welder.
Want this applied to your own numbers?
Every solution page carries a calculator that shows its own arithmetic — storage savings, lithium against lead-acid, and home pack sizing.